30
DSP
Setting the equalizer
You can select an equalizer curve for five
music types (Rock, Vocal, Groove, Techno, and
Custom).
You can store and adjust the equalizer settings
for frequency and level.
Selecting the equalizer curve
1
Press
(SOURCE)
to select a source (tuner,
CD, or MD).
2
Press
(SOUND)
repeatedly until “EQ”
appears.
Each time you press
(SOUND)
, the item
changes as follows.
EQ (equalizer curve)
t
POS (listening position)
t
BAL (right-left)
t
F (front speaker volume)
t
R (rear speaker volume)
t
SUB (subwoofer volume)
t
VOL (volume)
t
EQ (equalizer curve)
3
Press either side of
(SEEK/AMS)
to select
the desired equalizer curve.
Each time you press
(SEEK/AMS)
, the item
changes as follows.
Rock
y
Vocal
y
Groove
y
Techno
y
Custom
y
off
y
Rock
To cancel the equalizing effect, select “off.”
After three seconds, the display returns to
the normal playback mode.
Adjusting the equalizer curve
1
Press
(MENU)
.
2
Press either side of
(DISC/PRST)
repeatedly until “EQ Tune” appears, then
press
(ENTER)
.
3
Press either side of
(SEEK/AMS)
to select
the desired equalizer curve, then press
(ENTER)
.
Each time you press
(SEEK/AMS)
, the item
changes as follows.
Rock
y
Vocal
y
Groove
y
Techno
y
Custom
y
off
y
Rock
4
Select the desired frequency and level.
1
Press either side of
(SEEK/AMS)
to
select the desired frequency.
Each time you press
(SEEK/AMS)
, the
frequency changes as follows:
62 Hz
y
157 Hz
y
396 Hz
y
1.0 kHz
y
2.5 kHz
y
6.3 kHz
y
16.0 kHz
2
Press either side of
(DISC/PRST)
to
adjust the desired volume level.
The volume is adjustable by 1 dB steps
from –12 dB to +12 dB.
To restore the factory-set equalizer curve,
press
(ENTER)
for two seconds.
5
Press
(MENU)
twice.
When the effect setting is complete, the
normal playback mode appears.
