24
Error displays/Messages
*1
When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2
The disc number of the disc causing the error
appears in the display.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set to the monaural reception mode (page
18).
A programme broadcast in stereo is heard
in monaural.
• The unit is in monaural reception mode.
t
Cancel monaural reception mode (page
18).
Interference occurs during FM reception.
The wide mode is selected.
t
Set the IF mode to “IF AUTO” (page 18).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
BLANK
*
1
No tracks have been recorded on an MD.*
2
t
Play an MD with recorded tracks on it.
ERROR
*
1
• An inserted CD is dirty or inserted upside
down.*
2
t
Clean or insert the CD correctly.
• An inserted CD/MD cannot play because of
some problem.*
2
t
Insert another CD/MD.
FAILURE
The connection of speakers/amplifiers is
incorrect.
t
See the installation guide manual of this
model to check the connection.
HI TEMP
The ambient temperature is more than 50°C.
t
Wait until the temperature goes down
below 50°C.
NO DISC
No disc is inserted in the CD/MD unit.
t
Insert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD/
MD unit.
t
Insert the magazine in the CD/MD unit.
NO MUSIC
A CD which is not a music file is inserted in
the MP3 playable CD unit.
t
Insert a music CD in the MP3 playable CD
unit.
NOTREADY
The lid of the MD unit is open or the MDs are
not inserted properly.
t
Close the lid or insert the MDs properly.
OFFSET
There may be an internal malfunction.
t
Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
RESET
The CD/MD unit cannot be operated because
of some problem.
t
Press the RESET button on the unit.
