13
Maintenance
Fuse replacement
When replacing the fuse, be
sure to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse
blows again after replacement,
there may be an internal
malfunction. In such a case,
consult your nearest Sony
dealer.
Cleaning the connectors
The unit may not function properly if the connectors
between the unit and the front panel are not clean. In
order to prevent this, detach the front panel (page 4)
and clean the connectors with a cotton swab. Do not
apply too much force. Otherwise, the connectors
may be damaged.
Notes
•
For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
•
Never touch the connectors directly with your fingers
or with any metal device.
Removing the unit
1
Remove the protection collar.
1
Detach the front panel (page 4).
2
Engage the release keys together with the
protection collar.
3
Pull out the release keys to remove the
protection collar.
2
Remove the unit.
1
Insert both release keys simultaneously
until they click.
2
Pull the release keys to unseat the unit.
3
Slide the unit out of the mounting.
Fuse (10 A)
Main unit
Back of the front
panel
Orient the release
keys as shown.
Hook facing
inwards.
