8
Radio
Storing and receiving
stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press
(SOURCE)
repeatedly until
“TUNER” appears.
To change the band, press
(MODE)
repeatedly. You can select from FM1, FM2,
FM3, AM1 or AM2.
2
Press and hold
(BTM)
until “BTM”
flashes.
The unit stores stations in order of frequency
on the number buttons.
A beep sounds when the setting is stored.
Storing manually
1
While receiving the station that you
want to store, press and hold a
number button (
(1)
to
(6)
) until
“MEM” appears.
The number button indication appears in the
display.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
Receiving the stored stations
1
Select the band, then press a number
button (
(1)
to
(6)
) or
(GP/PRESET)
+/–.
With the card remote commander
To select preset stations, press
M
or
m
.
Tuning automatically
1
Select the band, then press
(SEEK)
–/+
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, press and hold
(SEEK)
–
/+ to locate the
approximate frequency, then press
(SEEK)
–
/+
repeatedly to fine adjust to the desired frequency
(manual tuning).
Receiving a station through a
list — list-up
You can list up the frequency or the name. For
details on labeling a station, see page 9.
1
Select the band, then press
(LIST)
.
The frequency or station name appears.
2
Press
(LIST)
repeatedly until the
desired station appears.
After 5 seconds, the unit returns to normal
reception mode.
3
Press
(SEEK)
–/+ to receive the
station.
