11
Other functions
Changing the sound settings
Adjusting the sound
characteristics
You can adjust the bass, treble, balance, fader
and subwoofer volume.
1
Select a source, then press
(SOUND)
repeatedly to select the desired item.
The item changes as follows:
BASS
(bass)
t
TREBLE
(treble)
t
BALANCE
(left-right)
t
FADER
(front-rear)
t
SUB WOOFER
(subwoofer volume)*
*
“
∞
” is displayed at the lowest setting, and can be
adjusted up to 20 steps.
2
Rotate the volume control dial
repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2, to adjust the selected item, press
<
or
,
.
Adjusting the equalizer curve
— EQ7 Tune
You can adjust and store the equalizer settings
for different tone ranges.
(With the card remote commander)
1
Select a source, then press
(MENU)
.
2
Press
M
or
m
repeatedly until “EQ7
Tune” appears, then press
(ENTER)
.
3
Press
<
or
,
repeatedly to select the
desired equalizer type, then press
(ENTER)
.
4
Press
<
or
,
repeatedly to select the
desired frequency.
The frequency changes as follows:
62Hz
y
157Hz
y
396Hz
y
1.0kHz
y
2.5kHz
y
6.3kHz
y
16kHz
5
Press
M
or
m
repeatedly to adjust the
desired volume level.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 4 and 5 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold
(ENTER)
.
6
Press
(MENU)
twice.
The setting is complete and the display
returns to normal play/reception mode.
Adjusting menu items — MENU
You can adjust various menu settings by using
the 4 arrow buttons on the card remote
commander.
(With the card remote commander)
1
Press
(MENU)
.
2
Press
M
or
m
repeatedly until the
desired item appears.
3
Press
<
or
,
to select the desired
setting (example: “on” or “off”).
4
Press
(ENTER)
.
The setting is complete and the display
returns to normal play/reception mode.
Note
Displayed items will differ, depending on the source
and setting.
Tip
You can easily switch among categories by pressing
and holding
M
or
m
.
The following items can be set (follow the page
reference for details):
“
z
” indicates the default settings.
Setup
Clock Adjust
(Clock Adjust) (page 4)
CT
(Clock Time)
To set “on” or “off” (
z
continue to next page
t
DSPL/PTY
MENU
SCRL
LIST
+
–
ENTER
