14
Rotary commander RM-X4S
Attaching the label
Attach the indication label depending on how
you mount the rotary commander.
Location of controls
The corresponding buttons on the rotary
commander control the same functions as those
on this unit.
The following controls on the rotary commander
require a different operation from the unit.
•
PRESET/DISC control
The same as
(GP/PRESET)
+/– on the unit
(push in and rotate).
•
VOL (volume) control
The same as the volume control dial on the unit
(rotate).
•
SEEK/AMS control
The same as
(SEEK)
–/+ on the unit (rotate, or
rotate and hold).
Changing the operative direction
The operative direction of the controls is factory-
set as shown below.
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
1
While pushing the VOL control, press and
hold
(SOUND)
.
Tip
You can also change the operative direction of these
controls in the menu (page 12).
Auxiliary audio equipment
You can connect optional Sony portable devices
to the BUS AUDIO IN/AUX IN terminal on the
unit. If the changer or other device is not
connected to the terminal, the unit allows you to
listen to the portable device on your car speakers.
Note
When connecting a portable device, be sure BUS
CONTROL IN is not connected. If a device is
connected to BUS CONTROL IN, “AUX” cannot be
selected with
(SOURCE)
.
Tip
When connecting both a portable device and a
changer, use the optional AUX-IN selector.
Selecting auxiliary equipment
1
Press
(SOURCE)
repeatedly until “AUX”
appears.
Operate by the portable device itself.
To adjust the volume level of auxiliary
equipment, see “AUX Level” on page 12.
SOUND
DSPL
MODE
SOUND
DSPL
MODE
OFF
ATT
SOUND
SOURCE
DSPL
MODE
OFF
VOL
SEEK/AMS
PRESET/
DISC
To increase
To decrease
