20
4
Rotate the control dial to select “1,” “2”
or “3,” then press it.
5
Press
(BACK) to return to the
previous display.
For details on the settings for the subwoofer
phase, position, low pass filter frequency
and the low pass filter slope, see page 21.
Adjusting setup items
1
Press
, rotate the control dial
until the desired category appears, then
press it.
2
Rotate the control dial until the desired
item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.
*
The setting is complete.
4
Press
(BACK) to return to the
previous display.
* For CLOCK-ADJ and BTM settings, step 4 is
not necessary.
The following items can be set depending
on the source and setting:
GENERAL:
*1 When the unit is turned off.
*2 Does not appear in App Remote.
*3 When the tuner is selected.
*4 When the CD or USB is selected.
SOUND:
CLOCK-ADJ
(Clock Adjust) (page 4)
CAUT ALM
*
1
(Caution Alarm)
Activates the caution alarm: “ON,”
“OFF” (page 4).
BEEP
Activates the beep sound: “ON,” “OFF.”
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: “NO,”
“30S (Seconds),” “30M (Minutes),” “60M
(Minutes).”
AUX-A
*
1
*
2
(AUX Audio)
Activates the AUX source display: “ON,”
“OFF” (page 23).
REAR/SUB
*
1
Switches the audio output: “SUB-OUT”
(subwoofer), “REAR-OUT” (power
amplifier).
CT
(Clock Time)
Activates the CT function: “ON,” “OFF”
(page 9).
BTM
*
3
ZAPPIN
*
4
ZAP TIME
(Zappin Time)
Selects the playback time for the
ZAPPIN function.
– “Z.TIME-1 (about 6 seconds),”
“Z.TIME-2 (about 15 seconds),”
“Z.TIME-3 (about 30 seconds).”
ZAP BEEP
(Zappin Beep)
Applies a beep sound between track
passages: “ON,” “OFF.”
EQ7 PRESET
EQ7 SETTING
POSITION
SET F/R POS
(Set Front/Rear Position)
ADJ POSITION
*
1
(Adjust Position)
SET SW POS
*
1
*
2
(Set Subwoofer
Position) (page 18)
BALANCE
Adjusts the sound balance: “RIGHT-15”
– “CENTER” – “LEFT-15.”
