22
Radio reception
Preset tuning is not possible.
•Store the correct frequency in the memory.
•The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
•Connect a power antenna control lead
(blue) or accessory power supply lead
(red) to the power supply lead of a car’s
antenna booster. (Only when your car has
built-in FM/AM antenna in the rear/side
glass.)
•Check the connection of the car antenna.
•The auto antenna will not go up.
t
Check the connection of the power
antenna control lead.
•Check the frequency.
Automatic tuning is not possible.
•The local seek mode is set to “ON.”
t
Set the local seek mode to “OFF”
(page 16).
•The broadcast signal is too weak.
t
Perform manual tuning.
The “ST” indication flashes.
•Tune in the frequency accurately.
•The broadcast signal is too weak.
t
Set to the monaural reception mode
(page 16).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t
Cancel monaural reception mode
(page 16).
Interference occurs during FM reception.
The wide mode is selected.
t
Set the IF mode to “IF AUTO” (page 16).
Error displays/Messages
Error displays
The following indications will flash for about 5
seconds, and an alarm sound will be heard.
ERROR
•A CD is dirty or inserted upside down.
t
Clean or insert the CD correctly.
•A CD cannot play because of some
problem.
t
Insert another CD.
HI TEMP
The ambient temperature is more than 50°C
(122°F).
t
Wait until the temperature goes down
below 50°C (122°F).
RESET
The CD unit cannot be operated because of
some problem.
t
Press the RESET button on the unit.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
Messages
L.SEEK +/–
The Local Seek mode is on during automatic
tuning (page 11).
“
” or “
”
You have reached the beginning or the end
of the disc and you cannot go any further.
Summary of Contents for CDX-L600X - Fm/am Compact Disc Player
Page 23: ...23 ...
