Sony CHP-411D, Operating Instructions Manual

8 (E)

Optical characteristics

Projection system 3 picture tubes, 3 lenses, Horizontal

inline system, Rear projection type

Picture tube

7-inch monochrome tubes, with
coolant sealed (5.5-inch raster size)

Projection lens

F1.1/77mm

Projected picture size

RVP-411DS/411DMS: 41 inches
measured diagonally

Luminance

RVP-411DS/411DMS with the
VPS-411RF screen:
ANSI (cd/m

 2

)

1)

  280 cd/m

 2

Peak 600 ft-L (2056 cd/m

2

)

Light output

ANSI lumen

1)

110 lm

Electrical characteristics

Input signal

Analog RGB signal
When an optional PWB-411D
video input board is attached:
analog color difference signal,
PAL, SECAM, NTSC and NTSC

4.43

Resolution

800 

×

 560 dots (RGB input at 31.25

kHz/50 Hz)

Frequency range

30 MHz, –3 dB

Input frequency

31.25 kHz/50 Hz/1:1, 31.25 kHz/
100 Hz/2:1, 31.5 kHz/
60 Hz/1:1, 31.5 kHz/120 Hz/2:1
(Horizontal frequency/Vertical
frequency/Interlace ratio)
allowance ±1%
15.625 kHz/50 Hz/2:1, 15.75 kHz/
60 Hz/2:1 (when an optional PWB-
411D video input board is used)

Test signal

2)

Cross hair/hatch (fine)/diagonal/
circle/dot/H/ME/window/all white/
black

Specifications

Inputs

 RGB signal
R, G, B: 0.7Vp-p±2dB, 75 ohms

terminated

G signal with sync input:

1.0Vp-p±2dB, 75 ohms
terminated, sync negative

HD, VD: 1.0–4.0Vp-p, 75 ohms

terminated, positive/negative

SYNC: composit sync input, 1.0–

4.0Vp-p, 75 ohms terminated,
positive/negative

 Y, R-Y, B-Y signal (when an
 optional video input board is
 attached)
Y: 1.0Vp-p±2dB, 75 ohms

terminated, sync negative

R-Y, B-Y: 0.7Vp-p±2dB, 75 ohms

terminated

 Video signal (when an optional
 video input board is attached)
Composite video input:  BNC

connector, 1.0Vp-p±2dB, 75
ohms terminated, sync negative

Y: BNC connector, 1.0Vp-p±2dB,

75 ohms terminated, sync
negative

C: BNC connector, burst level,

0.286Vp-p±2dB, 75 ohms
terminated (NTSC)
0.3Vp-p±2dB, 75 ohms
terminated (PAL)

REMOTE IN: D-sub 9-pin

connector (See “Signal
assignment” on page 9 (E).)

CONTROL S IN: minijack
ABL LINK IN: minijack

Outputs

REMOTE OUT: D-sub 9-pin

connector (See “Signal
assignment” on page 9 (E).)

CONTROL S OUT: minijack
ABL LINK OUT: minijack

.......................................................................................................................................................................................................

1) ANSI lumen and cd/m

2

 are measuring methods of American National Standard IT 7.215.

2) Inputting the 15 kHz sequential scanning signal may affect the test signal.