Sony CMT-BX7DAB, Operating Instructions Manual

CMT-BX7DAB.GB.3-095-508-11(1)

GB

Play does not start from the first 

track.



 Set the play mode to Normal Play 

mode.

Files cannot be played back.



 USB storage media formatted with file 

systems other than FAT16 or FAT32 

are unsupported.*



 If you use partitioned USB storage 

media, only files on the first partition 

can be played.



 Files that are encrypted or protected by 

passwords, etc. cannot be played back.

*  This system supports FAT16 and FAT32, but 

some USB storage media may not support all 

of these FAT. For details, see the operation 

manual of each USB storage media or 

contact the manufacturer.

Tuner

Severe hum or noise, or stations 

cannot be received. (“TUNED” or “ST” 

flashes on the display.)



 Connect the antenna properly.



 Find a location and an orientation that 

provide good reception, and then set 

up the antenna again.



 Keep the antennas away from the 

speaker cords, the power cord and the 

USB cable to avoid picking up noise.



 Connect a commercially available 

external antenna.



 Consult your nearest Sony dealer if the 

supplied AM antenna has come off the 

plastic stand.



 Turn off nearby electrical equipment.

“TUNED” does not appear in the 

display (DAB only).



 Check all antenna connections, then 

perform the DAB Automatic Scan 

procedure (see page 12).



 The current DAB service may not be 

available. Press +/



 (or TUNE +/



on the unit) 



 to select a different 

service.



 If you have moved to another area, 

some services/frequencies may have 

changed and you may not be able 

to tune into your usual broadcast. 

Perform the DAB Automatic Scan 

procedure to re-register the contents of 

broadcasts. (Performing this procedure 

clears all previously stored presets.)

To improve tuner reception

Turn off CD player power by using the 

CD power management function. By 

default, CD power is turned on.

1 

Press FUNCTION 



 repeatedly to 

select the CD function, and then turn 

off the system.

2 

After “STANDBY” stops flashing, press 



/





 on the unit while holding 

down 



/CANCEL 



 on the unit. 

“CD POWER OFF” appears. With CD 

player power turned off, disc access 

time is increased. To turn on CD 

player power, repeat the procedure 

until “CD POWER ON” appears.

To reset the system to factory settings

If the system still does not operate 

properly, reset the system to factory 

settings.

Use buttons on the unit to reset the 

system to its factory default settings.

1 

Disconnect and reconnect the power 

cord, and then turn on the system.

2 

Press 





 , 



/CANCEL 



 and 



/





 at the same time.

All user-configured settings, such as 

preset radio stations, timer, and the 

clock, are deleted.