T
une
r
13
GB
6
Press – or + (or TUNING – or + on the
unit) repeatedly to select the desired
preset number.
7
Press ENTER.
8
Repeat steps 2 through 7 to store other
stations.
Tip
Press TUNING MODE to stop scanning.
Manual tuning preset
You can manually tune in and store the radio
frequency of the desired stations.
1
Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
tuner.
2
Press TUNER BAND repeatedly to
select “FM” or “AM”.
3
Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
4
Press – or + (or TUNING – or + on the
unit) repeatedly to tune in the desired
station.
5
Press TUNER MEMORY.
6
Press – or + (or TUNING – or + on the
unit) repeatedly to select the desired
preset number.
7
Press ENTER.
8
Repeat steps 2 through 7 to store other
stations.
Other operations
To improve tuner reception
When tuner reception is poor, set CD player
power off by CD power manage function.
CD power is factory set to on. Use buttons on the
unit for the operation.
1
Press CD.
2
Press
?/1
to turn off the system.
3
Press
?/1
while holding
x
.
“CD POWER OFF” appears.
To set CD power on
Repeat the procedure above and “CD POWER
ON” appears.
Notes
• When “CD POWER OFF” is selected, disc access
time is increased.
• You cannot change the setting in Power Saving
Mode (page 23).
To change the AM tuning interval
(except for European, Russian
and Saudi Arabian models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
x
, press
?/1
on the unit. When you change the interval,
all the AM preset stations are erased. To reset
the interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 23).
Tips
• The preset stations are retained for about half a day
even if you disconnect the power cord or if a power
failure occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
To
Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset”
(page 13).
Set another station
to the existing
preset number
After step 5, press – or + (or
TUNING – or + on the unit)
repeatedly to select the preset
number you want to store the
station.
