34
GB
CMT-M80V 4-241-367-12(1) GB
Problems and remedies (continued)
Optional components
There is no sound.
• Refer to General item “There is no sound.” on
page 32 and check the condition of the system.
• Connect the component properly (see page 30)
while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
The sound is distorted.
• Set the volume of the connected component
lower.
The sound from the component connected to the
AUDIO IN MD (VIDEO) jacks is distorted.
• If “VIDEO” appears when you press
FUNCTION repeatedly, switch the function to
“MD” (see the tip for “Listening to audio from a
connected component” on page 31).
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (see page 17).
• Connect the antenna properly (see page 6).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend
you connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend
it fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical
equipments.
A stereo FM program cannot be received in
stereo.
• Press REPEAT/FM MODE until “STEREO”
appears in the display.
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1
Disconnect the mains lead.
2
Reconnect the mains lead.
3
Press
?/1
to turn on the system.
4
Press FUNCTION while pressing
z
REC
and
?/1
.
The system is reset to the factory settings. All
the settings you made such as the preset
stations, clock, and timer are cleared and must
be set again.
Note
You cannot reset the system in Power Saving Mode.