Sony CMT-NEZ7DAB, Operating Instructions Manual

T

uner

13

GB

Before you can receive DAB, you must register 
the contents of broadcasts (service components) 
so that they can be received by the DAB tuner 
using the DAB Automatic Scan procedure.

DAB Automatic Scan

DAB Automatic Scan starts automatically only 
when you turn on the system for the first time 
after you purchase the system.
If you want to use the DAB Automatic Scan 
again, perform the procedure below.

1

Press DAB AUTO SCAN on the unit.

“DAB Auto Scan? Push DAB” appears.

2

Press DAB on the unit.

Scanning begins. “DAB Auto Scan” 
appears. Depending on the DAB services 
available in your area, scanning may take a 
few minutes.

When scanning is complete, available 
service component list is created.

Notes

• If your country or region does not support DAB 

broadcast, “No Service” appears.

• Do not press any button on the unit or supplied 

remote during DAB Automatic Scan. Scanning is 
interrupted and service component list may not be 
created properly. In this case, perform the DAB 
Automatic Scan again.

• If you move to another area, repeat this procedure to 

store the stations for your new area.

• This procedure clears all previously stored presets.

• This procedure does not create any presets.

To move system location

When you wish to move the system to a new 
location, to preserve your own DAB settings, 
make sure the clock display* appears when the 
system is powered down, before unplugging the 
mains lead and DAB lead aerial.

* In Power Saving Mode, make sure the clock display 

disappears.

You can preset up to 20 DAB stations, 20 FM 
stations and 10 AM stations. You can then tune 
in any of those stations simply by selecting the 
corresponding preset number.

Automatic tuning preset

You can automatically tune in all of the service 
components or stations that can be received in 
your area and then store them.

1

Press TUNER/BAND (or FUNCTION 
repeatedly) to switch the function to 
TUNER.

2

Press TUNER/BAND repeatedly to 
select “DAB”, “FM” or “AM”.

You can also use the DAB button to select 
DAB directly.

3

Press TUNING MODE repeatedly until 
“AUTO” appears in the display.

4

Press + or – (or  or – on the 
unit).

Service component list is played downward 
(DAB) or the frequency changes as the 
system scans for a station (FM/AM). 
Scanning stops automatically when a 
station is tuned in. At that time, “TUNED” 
and “STEREO” (for stereo program only) 
appear.

If “TUNED” does not appear and the 
scanning does not stop

Set the frequency of the desired radio 
station as described in steps 3 and 4 of 
“Manual tuning preset (FM/AM bands 
only)” (page 14).
Manual tuning is not available for DAB.

Tuner

Scanning DAB stations

Presetting radio stations

continued