CPD-E200E
2-5. H BOARD REMOVAL
1
Screw
(+BVTP 4 x 16)
3
Claw
4
H board
Picture tube
Bezel
Cushion
5
Menu button
2
H bracket
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow
c
.
• HOW TO HANDLE AN ANODE-CAP
1
Don’t scratch the surface of anode-caps with shartp shaped mate-
rial!
2
Don’t press the rubber hardly not to damege inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
a
b
Anode Button
c
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,
after removing the anode.
• REMOVING PROCEDURES
1
Turn up one side of the rubber cap in
the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
b
.
2-4
Summary of Contents for CPD-E200E
Page 20: ...CPD E200E 4 4 MEMO ...
