10(E)
Locations and Functions of Parts
1
DRIVE power switch
This is for turning the power to the drive block on and
off.
When turning on the power, set it to the
I
position
(ON).
To turn the power off, set it to the
a
position (OFF).
Notes
• When you also use the redundant power unit, set the
power switches to OFF on the both power units.
• When you turn the power on immediately after you
turn it off, wait for at least 5 seconds.
2
ROBOT power switch
This is for turning the power to the robot block on and
off.
When turning on the power, set it to the
I
position
(ON).
To turn the power off, set it to the
a
position (OFF).
When the power is turned off, all indicators on the
display panels go dark.
Notes
• When you also use the redundant power unit, set the
power switches to OFF on the both power units.
• When you turn the power on soon after you turn it off,
wait until the indicator on the display panel goes off.
Warning
This system has four power-reception (AC inlet) lines.
In an emergency, be sure to disconnect all power cords
to completely shut off the power supply.
3
Display panel
The operating conditions, status, etc., of the system
appear here. Using this panel, initialization of the
system, and menu operation for checking the system
configuration and hour meters are also possible.
For details, see “Display Panel” on page 11(E).
4
IN/OUT ports
These ports are for loading and removing cartridges.
You can mount a magazine containing up to six
cartridges in a port.
Care must be taken to load the cartridges in the right
direction.
For details, see “IN/OUT Ports” on page 12(E).
5
PetaSite Control Unit
The unit controls and monitors the drives and robot
block.
For details, see “PetaSite Control Unit (PCU)” on page
12(E).
6
Transfer check window
The position of a transfer may be checked through this
window.
