2-1
2. DISASSEMBLY
DSC-W200_L2
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don’t pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
DISCHARGING OF THE ST-167 BOARD’S CHARGING CAPACITOR (C901)
The charging capacitor (C901) of the ST-167 board is charged
up to the maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by
the charged voltage which is kept without discharging when the
main power of the unit is simply turned off. Therefore, the
remaining voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of
a resistor of 1 k
Ω
/1 W (1-215-869-11).
Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.
1 k
Ω
/1 W
Wrap insulating tape.
Note:
High-voltage cautions
Discharging the Capacitor
Turn the ST-168 flexible board.
Short-circuit between the two points with the short jig about 10 seconds.
To avoid the spark with the metal plate,wrap the short jig with the
insulation tape.
R:1 k
Ω
/1 W
(Part code: 1-215-869-11)
Charging
Capacitor
(C901)
two holes of the
battery holder
ST-168 flexible board
ST-167 board
