DSC-W530_L2
3-1E
3. ASSEMBLY
Assembly-1:
Installation Method of Battery Terminal Board
Insert the battery terminal board into a slit in
BT holder to install.
* Battery terminal board is attached with
notch for installation.
Remove the battery terminal board by
bending the claw of rock portion.
When assembling the battery terminal board,
replace it with new one because battery ]
terminal board will be bent.
Fold the notch 3 or 4 times repeatedly to break.
Remove the notch.
Notch
Battery terminal board
Battery terminal board
Notch
Battery terminal
board
Notch
Assembly-2:
Insulating Sheet (670) Putting Position
Insulating Sheet (670)
SY-285 Board
Insulating Sheet (670)
Assembly-3:
Precaution During of MA-473 Flexible Board
Installation.
Route the speaker harness and microphone
harness as shown below.
Speaker
Harness
Tape SP
Microphone
Harness
MA-473 Flexible
Board
Microphone
Harness
MA-473 Flexible
Board
Assembly-4:
Precaution During of Cabinet (Rear) Assy
Installation.
Align the slide switch at the camera mode,
when install cabinet (rear) assy.
Slide Switch
Cabinet (Rear) Assy
Assembly-5:
Attaching Method of LCD Cushion (700),
LCD Window (670)
Apply LCD cushion (700).
And have the Tab of the Release Paper and peel it off.
Attach Cabinet (Rear) Assy to set.
Cabinet (Rear) Assy
Mike Lid (700)
Fit LCD Window (670) into the flame of
Cabinet (Rear) Assy and attach it on LCD Cushion (700).
LCD Cushion (700)
LCD Window (670)
Rear Cabinet Assy
Blow the air before attaching.
Be sure to keep away from dust.
LCD Cushion (700)
LCD
Align corner of
LCD cushion (700)
with corner of LCD.
Tab
Release Paper
