Ge
tti
ng Sta
rte
d –
AD
V
ANCED –
17
GB
You can use the speakers by installing on the
wall.
Installing the speakers on a
wall
1
Prepare screws (not supplied) that are
suitable for the hole on the back of
each speaker. See the illustrations
below.
2
Fasten the screws to the wall.
3
Hang the speakers on the screws.
Note
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them
to the wall. Install the speakers on a vertical and flat
wall where reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
Installing the Speakers on
a Wall
25 mm (1inch)
4 mm (
5
/
32
inch)
Hole on the back of
the speaker (except
for the center
speaker)
4.6 mm
(
3
/
16
inch)
10 mm
(
13
/
32
inch)
6 to 9 mm
(
1
/
4
to
3
/
8
inch)
4.6 mm
(
3
/
16
inch)
10 mm
(
13
/
32
inch)
Rear of speaker
