18
US
After connecting the AC power cord (mains
lead), the demonstration appears in the front
panel display. When you press
"
/
1
on the
remote, the demonstration turns off.
Note
• When you press
"
/
1
on the unit, the demonstration
does not turn off.
• When you set the demonstration mode in the system
menu to on, the demonstration does not turn off even
though you press
"
/
1
on the remote. To turn off the
demonstration, set the demonstration mode to off,
then press
"
/
1
on the remote. When the
demonstration mode is set to off, the system saves
power in standby mode.
• If the system is at its factory default settings (ex. after
performing “COLD RESET” (page 74)), you can turn
off the demonstration simply by pressing
"
/
1
on the
remote. Otherwise, to stop the demonstration, you
need to set “DEMO” to “DEMO OFF.”
Setting the demonstration
mode to on/off
1
Press SYSTEM MENU.
2
Press
X
/
x
repeatedly until “DEMO”
appears in the front panel display, then
press
or
c
.
3
Press
X
/
x
to select a setting.
The default setting is underlined.
• “DEMO ON”: sets the demonstration
mode to on.
• “DEMO OFF”: sets the demonstration
mode to off.
4
Press .
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
Getting Started – ADVANCED –
Turning off the
Demonstration
SYSTEM
MENU
"
/
1
X/x/c
,
