Contr
o
l f
o
r HDMI/
Extern
al A
u
dio
D
e
vic
e
67
US
Note
• When you turn the system off while “S-AIR STBY”
is set to “STBY ON,” “S-AIR” flashes (when sound
transmission between the unit and S-AIR receiver is
not established), or lights up (when sound
transmission between the unit and S-AIR receiver is
established) in the front panel display.
It is easy to set the same ID for the unit and an
S-AIR sub unit, such as a surround amplifier or
S-AIR receiver, to establish sound transmission.
However, neighbors may also receive your
system’s sound if IDs are the same, or you may
receive sound from neighbors. To prevent this,
you can identify the unit with a specific S-AIR
sub unit by performing the pairing operation.
x
Before pairing
Sound transmission is established by ID
(example).
x
After pairing
Sound transmission is established between the
paired unit and S-AIR sub unit(s) only.
To perform pairing
1
Place the S-AIR sub unit that you want
to pair near the unit.
Note
• Remove headphones from the surround
amplifier (if connected).
2
Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see “To set the ID
• To set the ID of the S-AIR sub unit, refer
to the operating instructions of the S-AIR
sub unit.
3
Press SYSTEM MENU.
4
Press
X
/
x
repeatedly until “PAIRING”
appears in the front panel display, then
press
or
c
.
Note
• When the wireless transmitter is not inserted in
the unit, “PAIRING” cannot be selected.
5
After “START” appears in the front
panel display, press
.
The unit starts pairing and “SEARCH”
flashes in the front panel display.
To cancel pairing, press SYSTEM MENU.
Identifying the unit with a
specific S-AIR sub unit
(Pairing operation)
For the surround amplifier
For the S-AIR receiver
This unit
ID A
ID A
S-AIR sub unit
ID A
S-AIR sub unit
Your room
Neighbor
This unit
ID A
S-AIR sub unit
ID A
ID A
S-AIR sub unit
Your room
Neighbor
Pairing
No transmission
