1-3
DCR-SR190E/SR200/SR200C/SR200E/SR290E/SR300/SR300C/SR300E_L2
ENGLISH
JAPANESE
ENGLISH
JAPANESE
1-3. METHOD OF COPING WITH SHIFT LENS ERROR (SR290E/SR300/SR300C/SR300E)
about 330 msec
Fig. 2
Change in output voltage of R5792 on the VC-492 board
Note: The length of low section will vary a little depending on the
conditions.
Fig. 1
Measurement points on the VC-492 board
1-3-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
Procedure
1
Turn the power OFF.
2
While measuring with an oscilloscope the output voltage of R5792 in the periphery of IC5703 on the VC-492 board, turn the
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
3
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
the camera control circuit (IC1803 of VC-492 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
18
IC1803
R1846
R5792
IC5703
R5721
R5737
VC-492 BOARD (SIDE B)