2-9
DCR-TRV60/TRV60E/TRV70
2-8. LB-086 BOARD
qh
LB-086 board
9
LB-086 board assembly
qg
Lamp guide (20)
q;
Illuminator
qa
Prism sheet
qs
LCD
qd
VF lens assembly
6
VF electrostatic sheet (A)
VF electrostatic
sheet (A)
4
VF cabinet (upper) assembly
Caution
Caution
Caution
5
FP-659 flexible
board (16P)
FP-659 flexible
board (16P)
Two claws
qf
Two claws
8
Three claws
1
Two tapping
screws
(M1.7
×
5)
VF lens assembly
2
Remove the EVF block in the
direction of the arrow
A
by
releasing the two claws.
Be careful that the pin of the VF lens assembly
comes to the position as shown in the
illustration when re-assembling it.
Drawing when viewed
from the side
Drawing when viewed
from the side
Drawing when viewed
from the bottom
The concave surface
of the VF lens assembly
Attach the VF electrostatic sheet (A) as shown.
3
Remove the VF lens
assembly from the VF
cabinet (upper)
assembly in the
direction of the arrow.
A
Tape
Cushion (C)
Hole
Hole
Shaft
Contact point
Give a folding mark along with
the dotted line as shown.
Align the FP-659 flexible board
(16 P) with the attached tape as
the reference line.
Contact point
Attach the cushion "c" to the position
shown by the dotted line.
While the contact point faces
upwovd, pass through it in the
direction the arrow.
7
Flexible board
(from the LCD)
(16P)
www.freeservicemanuals.info
Digitized in Heiloo Netherland