GB
Additional information
Troubleshooting
If you run into any problems using this
product, follow the steps below.
Check the list (p. 42 to 43), and
inspect this product.
Remove the power source, attach
the power source again after about 1
minute, and turn this product on.
Press RESET (p. 53) using a pointed
object, and turn this product on.
If you press
RESET
, all settings,
including the clock setting, are reset.
Contact your Sony dealer or local
authorized Sony service facility.
See the Digital Recording Binoculars Handbook
(p. 12) for details on the symptoms of this
product, and “PMB Help” (p. 37) on connecting
this product to a computer.
The power does not turn on.
Attach a charged battery pack to this product
(p. 17).
Connect the plug of the AC Adaptor to the
wall outlet (wall socket) (p. 20).
This product does not operate even when
the power is set to on.
It takes a few seconds for this product to be
ready to shoot after the power is turned on.
This is not a malfunction.
Disconnect the AC Adaptor from the wall
outlet (wall socket) or remove the battery
pack, then reconnect it after about 1 minute. If
this product still does not work, press RESET
(p. 53) using a pointed object. (If you press
RESET, all settings, including the clock setting,
are reset.)
The temperature of this product is extremely
high. Turn off this product and leave it for a
while in a cool place.
The temperature of this product is extremely
low. Leave this product with the power turned
on. If you still cannot operate this product,
turn off this product and take it to a warm
place. Leave this product there for a while,
then turn on this product.
This product gets warm.
This product may become warm during
operation. This is not a malfunction.
The power abruptly turns off.
Use the AC Adaptor (p. 20).
Charge the battery pack (p. 17).
Pressing START/STOP or PHOTO does not
record images.
Press MODE to turn on the (Movie) or
(Photo) lamp.
This product is recording the image you have
just shot on the memory card. You cannot
make any new recordings during this period.
The memory card is full. Delete unnecessary
images.
Total number of movie scenes or photos
has exceeded the recordable capacity of this
product (p. 45). Delete unnecessary images.
The recording stops.
The temperature of this product is extremely
high/low. Turn off this product and leave it for
a while in a cool/warm place.
”PMB” cannot be installed.
Check the computer environment or
installation procedure required to install
“PMB” (p. 34).
”PMB” does not work correctly.
Quit “PMB” and restart your computer.
Summary of Contents for DEV-3 Digital Recording Binoculars
