54
GB
SONY TV DIRECT allows you to turn on your
SONY TV and this system, change the system
mode to “DVD”, and then switch the TV’s input
source you set with one button push.
Use the remote for the operation.
1
Press and hold TV/VIDEO while
entering the code for the TV’s input
source connected to this system (see
the table below) using the numeric
buttons.
TV’s input source is selected.
2
Press and hold TV CH + while entering
the code for transmit time (see the
table below) using the numeric
buttons.
The transmit time from the remote is
selected.
Notes
• This function is only for SONY TV series, however,
some TV products may also not work.
• If this function does not work, change the transmit
time. The transmit time varies depending on the TV.
• If distance between the TV and this system is too far,
this function may not work. Install the system near
the TV.
• Keep the remote pointed in the direction of the TV
and this system.
Using the SONY TV DIRECT
function
By pressing Number
TV’s input source
TV/VIDEO
0
No input source
(Default)
1
VIDEO1
2
VIDEO2
3
VIDEO3
4
VIDEO4
5
VIDEO5
6
VIDEO6
7
COMPONENT 1
INPUT
8
COMPONENT 2
INPUT
By pressing Number
TV’s input source
TV CH +
1
0.5
2
1
3
1.5 (Default)
4
2
5
2.5
6
3
7
3.5
8
4