C:\#WORK\@DPF\DPF-A72N\Writer-OP\06_FinalDelivery\GB\4155760111\4155760111DPF-A.E.D.72NCEK\040C02.fm
Master:
Left
DPF-A72N/E72N/D72N 4-155-760-
11
(1)
16
GB
When the photo frame is placed in the portrait
orientation, the image is also automatically
rotated to its proper orientation.
DPF-D72N only: The directions indicated on
the direction button on the rear panel depend on
the orientation of the photo frame.
Notes
• Check whether the stand is stable. If the stand is not
set properly, the photo frame may fall over.
• DPF-A72N/D72N only: When the photo frame is
placed in the portrait orientation, the Sony logo
doesn't light up.
• The photo frame does not detect and rotate the
orientation of images when [Auto display
orientation] of [General Settings] on the
(Settings) tab is set to [OFF].
• A magnet is contained in the storage portion of the
stand. Do not keep anything that is easily affected
by magnetism, such as a cash card or credit card,
near the photo frame.
If you place the photo frame near a cathode-ray tube
television, the colors of the television screen may be
affected.
Tip
It is easier to turn the stand if you wind or wrap a
rubber band tightly around the stand when you
remove the stand from the photo frame.
To display the photo
frame on the wall
You can hang the photo frame on the wall
using the following procedure.
1
Prepare screws (not supplied)
suitable for the screw holes on the
rear panel.
2
Screw the screws (not supplied) into
the wall.
Be sure the screws (not supplied) protrude
between 2.5 to 3mm (
1
/
8
inch) from the
surface of the wall.
3
Hang the photo frame on the wall by
fitting the one hole on the rear panel
to the screws on the wall.
Notes
• Use screws suitable for the quality of the material of
the wall. The screws may be damaged, depending
on the type of material used in the wall. Set the
screws in a pillar or stud in the wall.
4mm (
3
/
16
inch)
More than 25mm (1 inch)
4.2mm
(
3
/
16
inch)
8.6mm
(
11
/
32
inch)
Holes for hanging
the unit on the wall
Between
2.5mm to 3mm
(
1
/
8
inch)