18
GB
When the photo frame is placed in the portrait
orientation, the image is also automatically
rotated to its proper orientation.
The directions indicated on the direction button
on the rear panel depend on the orientation of
the photo frame.
Notes
• Check whether the stand is stable. If the stand is not
set properly, the photo frame may fall over.
• When the photo frame is placed in the portrait
orientation, the Sony logo doesn't light up.
• The photo frame does not detect and rotate the
orientation of images when [Auto display
orientation] on the
(Settings) tab is set to
[OFF].
• A magnet is contained in the storage portion of the
stand. Do not keep anything that is easily affected
by magnetism, such as a cash card or credit card,
near the photo frame. If you place the photo frame
near a CRT-based television, the color of the TV’s
display may be changed.
Tip
It is easier to turn the stand if you wind or wrap a
rubber band tightly around the stand when you
remove the stand from the photo frame.
To display the photo
frame on the wall
You can hang the photo frame on the wall
using the following procedure.
1
Prepare screws (not supplied)
suitable for the screw holes on the
rear panel.
2
Screw the screws (not supplied) into
the wall.
Be sure the screws (not supplied) protrude
between 2.5 to 3mm (
1
/
8
inch) from the
surface of the wall.
3
Hang the photo frame on the wall by
fitting the hole on the rear panel to
the screws on the wall.
Notes
• Use screws suitable for the quality of the material of
the wall. The screws may be damaged, depending
on the type of material used in the wall. Set the
screws in a pillar or stud in the wall.
4mm (
3
/
16
inch)
More than 25mm (1 inch)
4.2mm
(
3
/
16
inch)
8.6mm
(
11
/
32
inch)
Holes for hanging
the unit on the wall
Between
2.5mm to 3mm
(
1
/
8
inch)