DR-BT160iK_CED [
US
, ES] 4-108-812-42(1)
1
0
US
US
DR-BT160iK_CED [
US
, ES] 4-108-812-42(1)
1
0
US
US
Pairing with other
Bluetooth
devices
What is pairing?
Bluetooth
devices need to be “paired” with each other beforehand.
Once
Bluetooth
devices are paired, there is no need for pairing again,
except in the following cases:
• Pairing information is deleted after repair, etc.
• This product is paired with 9 or more receiving devices.
This product can be paired with up to 8
Bluetooth
device respectively.
If a new device is paired after 8 devices have been paired, the device
whose latest connection time is the oldest among the 8 paired devices
is replaced by the new one.
• This product is initialized.
All pairing information is deleted (page 38).
Pairing transmitter with other
Bluetooth
receiving devices
1
Turn on the power of iPod.
(Make sure the iPod is in pause mode.)
2
Connect the transmitter to the iPod (page 16).
3
Place the transmitter and the
Bluetooth
receiving device to be
paired together within 1 m (3 ft).
4
Set the
Bluetooth
receiving device to enter “Pairing in process.”
See the operating instructions supplied with the
Bluetooth
receiving device.
Notes
Passcode* of the transmitter is fixed at “0000,” “1234,” or “8888.”
Depending on the
Bluetooth
receiving device, it may be necessary to input
the passcode (in this case, “0000,” “1234,” or “8888”). The transmitter
cannot be paired with a
Bluetooth
receiving device whose passcode is not
“0000,” “1234,” or “8888.”
If the
Bluetooth
receiving device requires a passcode, input “0000.”
* Passcode may be called “Passkey,” “PIN code,” “PIN number,” or
“Password.”
•
•
Advanced operation
Continued
