XDR-CD70DAB 3-214-191-11(1)
XDR-CD70DAB 3-214-191-11(1)
3-214-191-11(1)
© 2007 Sony Corporation
Printed in China
XDR-CD70DAB
Dream Machine is a trademark of Sony Corporation.
DAB/FM CD Clock Radio
Operating Instructions
Features
Illumination (High/Low/Off)
Built-in audio cable for digital music players
Built-in CD player with CD-R/RW playback
function
DAB/FM 2-band digital tuner
6 station presets (3 DAB, 3 FM)
Automatic Time/Daylight Saving Time Setting
No Power No Problem Alarm System
Triple time display: A main display for the clock and
two sub-displays for the alarms
Nap Timer (Count Down Timer)
Extendable Snooze time from 10 to 60 min
Precautions
Use the power source specified in “Specifications” to
operate the unit.
The name plate indicating operating voltage, etc. is
located on the bottom of the AC power adaptor.
To disconnect the power cord (mains lead), pull it
out by the plug, not the cord.
Do not carry the unit by the FM/DAB wire antenna
Do not carry the unit by the FM/DAB wire antenna
and the AC power cord.
Do not leave the unit in a location near a heat source
such as a radiator or air duct, or in a place subject to
direct sunlight, excessive dust, mechanical vibration,
or shock.
Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on a surface (a rug,
blanket, etc.) or near materials that might block the
ventilation holes such as a curtain.
Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by a qualified
personnel before operating it any further.
When the casing becomes soiled, clean it with a soft
cloth dampened with mild detergent solution. Never
use abrasive cleansers or chemical solvents, as they
may mar the casing.
If you have any questions or problems
concerning your unit, please consult your nearest
Sony dealer.
Troubleshooting
Should the problem persists after you have made the
following checks, consult your nearest Sony dealer.
The clock flashes “AM 12:00” due to a power
interruption.
The battery is low. Replace the battery. Remove the
old battery and install a new one.
The CD, DAB, FM, or buzzer alarm does not sound
at the preset alarm time.
Hasn’t “ALARM A” or “ALARM B” in the display
gone out?
The CD, DAB, or FM alarm is activated but no
sound comes on at the preset alarm time.
Has VOLUME been adjusted ?
The CD player does not operate./
”00” flashes in the display for 5 seconds even
though a CD is inserted.
Did you close the CD compartment lid?
Did you insert the disc correctly?
The disc should be inserted with the label
side up.
Dusty or defective disc — Clean the disc with an
optional cleaning cloth. Wipe the disc from the
center out.
Take out the CD and leave the CD compartment
open for about an hour to allow condensation to
evaporate.
Sporadic loss of sound during CD operation.
Dusty or defective disc — Clean or replace the disc.
Excessively high volume — Reduce the volume.
Strong vibration.
There are scratches on the CD surface.
Insert
another CD.
No sound comes from the speakers.
Has VOLUME been adjusted ?
Specifications
CD player section
System:
Compact disc digital audio system
Laser diode properties:
Material: GaAlAs
Wavelength: 785 – 800 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a distance of
about 200 mm from the objective lens surface on
an optical pick-up block with a 7-mm aperture.)
Number of channels:
2
Frequency response:
20 – 20 000 Hz
+1
–2
dB
Wow and flutter:
Below measurable limit
Radio section
Frequency range:
FM: 87.5 – 108 MHz
DAB (Band-III): 174.928 (5A) -
239.200 (13F) MHz
DAB (Band-III) frequency table
(MHz)
No.
Channel
Frequency
1
5A
174.928
2
5B
176.640
3
5C
178.352
4
5D
180.064
5
6A
181.936
6
6B
183.648
7
6C
185.360
8
6D
187.072
9
7A
188.928
10
7B
190.640
11
7C
192.352
12
7D
194.064
13
8A
195.936
14
8B
197.648
15
8C
199.360
16
8D
201.072
17
9A
202.928
18
9B
204.640
19
9C
206.352
20
9D
208.064
21
10A
209.936
22
10B
211.648
23
10C
213.360
24
10D
215.072
25
11A
216.928
26
11B
218.640
27
11C
220.352
28
11D
222.064
29
12A
223.936
30
12B
225.648
31
12C
227.360
32
12D
229.072
33
13A
230.784
34
13B
232.496
35
13C
234.208
36
13D
235.776
37
13E
237.488
38
13F
239.200
Antennas:
FM/DAB: FM/DAB wire antenna
General
Time display:
12-hour system
Speaker:
50 mm diam., 8 Ω, cone type (2)
Input:
Built-in audio cable with stereo-mini plug (1):
minimum input level 245 mV, impedance
47 kΩ
Power outputs:
1 W + 1 W (at 8 Ω, 10% harmonic distortion)
Power requirements:
230 V AC, 50 Hz
For power backup: 3 V DC, one CR2032 battery
Dimensions:
Approx. 170
136
204 mm (w/h/d) incl.
projecting parts and controls
Mass:
Approx. 1 700 g incl. CR2032 battery
Design and specifications are subject to change
without notice.
No Power No problem is a trademark of Sony Corporation.
Initial Setting for the
Clock
This unit is preset to the current date and time at the
factory, and is powered by the back up battery.
1
Plug in the unit.
The current time appears in the display.
Note
Though the clock is correctly set at the factory,
discrepancies may arise during transport or storage. If
necessary, set the clock to the correct time by referring
to “Setting the Clock Manually” or “Setting the Date
Manually”.
When daylight saving time
(summer time) begins
This model automatically adjusts for daylight saving
time (summer time).
“ ” is displayed from the beginning of daylight saving
time (summer time) and disappears at the end of the
daylight saving time (summer time) automatically.
The summer time adjustment is based on GMT
(Greenwich Mean Time).
Daylight saving time (summer time) begins at: 1:00
Daylight saving time (summer time) begins at: 1:00
AM on the final Sunday of March.
Standard time begins at: 2:00 AM on the final
Standard time begins at: 2:00 AM on the final
Sunday of October.
Improving the
Reception
Extend the FM/DAB wire antenna fully to increase
reception sensitivity.
The following conditions may interfere with the
radio reception:
When the unit is placed on a steel desk or metal
When the unit is placed on a steel desk or metal
surface.
When the unit is near a metal surface (such as a
When the unit is near a metal surface (such as a
metal wall).
When the unit is near a digital music player that is
When the unit is near a digital music player that is
turned on.
DAB AUTO SCAN
FM/DAB
RADIO ON
Initial Setting for the
DAB
When you press
FM/DAB
RADIO ON
repeatedly to
select DAB for the first time after you purchase the
unit (or after resetting), DAB Automatic Scan starts
automatically and creates a list of available services.
If you want to run the DAB Auto Scan again or when
the unit is reset, do the following:
1
Press
FM/DAB
RADIO ON
repeatedly to
select DAB.
2
Press
DAB AUTO SCAN
.
“INITIAL?” appears in the display.
3
Press
DAB AUTO SCAN
again while
“INITIAL?” displays.
Scanning begins. The scanning progress is
indicated by advancing asterisks. Depending on
the DAB services available in your area, scanning
may take a few minutes.
Notes
If no list creates after DAB scan, “NOSIGNAL”
If no list creates after DAB scan, “NOSIGNAL”
appears in the display.
To cancel the DAB scan halfway, press
To cancel the DAB scan halfway, press
DAB AUTO
SCAN
. Any services received before you cancel are
added to the list of receivable services.
If you change the unit’s location of use, or want to
If you change the unit’s location of use, or want to
add a new service after the initial setting, do steps 1
to 3 of “Initial Setting for the DAB” above.
About the Backup
Battery
To keep good time, this unit contains one CR2032
battery inside of the unit as a backup power source.
The battery keeps the clock operating in the event of a
power interruption.
Knowing when to replace the
battery
When the battery becomes weak, “
” appears in the
display.
If a power interruption occurs while the battery is
weak, the current time and alarm will be initialized.
Replace the battery with a Sony CR2032 lithium
battery. Use of another battery may cause a fire or
explosion.
Note
If “AM 12:00” flashes in the display when the unit is
connected to AC outlet for the first time, the battery
may be weak. In this case, consult your Sony dealer.
Replacing the battery
1
Keep the AC plug connected to the AC
outlet and use a screwdriver to remove the
screw that secures the battery holder at the
bottom of the unit. (See Fig.
-
)
2
Push the exhausted battery out from the
bottom of the battery holder and insert a
new battery with the
side facing up. (See
Fig.
-
)
3
Insert the battery holder back into the unit
and secure it with the screw. (See Fig.
-
)
4
Press
FM/DAB
RADIO ON
to turn “
” off
in the display.
Note
When replacing the battery, do not disconnect AC
plug from AC outlet.
If you do, the current time, alarm and NAP timer will
be initialized.
Battery Warning
If the unit is to be left unplugged for a long time,
remove the battery to avoid undue battery discharge
and damage to the unit from battery leakage.
NOTES ON THE LITHIUM BATTERY
Dispose of the used battery promptly. Keep the
lithium battery out of the reach of children.
Should the battery be swallowed, consult a doctor
immediately.
Wipe the battery with a dry cloth to assure a good
contact.
Be sure to observe correct polarity when installing
the battery.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Do not expose the battery to excessive heat such as
direct sunlight, fire or the like.
WARNING
There is a danger of explosion if the battery is
incorrectly replaced.
Replace only with the same or equivalent type
recommended by the equipment manufacturer.
Push
Lift up with your finger
Display examples
Display
indicates
2 (two)
5 (five)
6 (six)
8 (eight)
0 (zero)
A
B
D
G
H
K
M
O
Q
R
S
Z
! or |
”
$
%
,
.
?
@
^
Disposal of Old Electrical & Electronic
Equipment (Applicable in the European
Union and other European countries
with separate collection systems)
This symbol on the product or on its packaging
indicates that this product shall not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product. The
recycling of materials will help to conserve natural
resources. For more detailed information about
recycling of this product, please contact your local
Civic Office, your household waste disposal service or
the shop where you purchased the product.
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Do not install the appliance in a confined space, such
as a bookcase or built-in cabinet.
To reduce the risk of fire or electric shock, do not
place objects filled with liquids, such as vases, on the
apparatus.
Connect the apparatus to an easily accessible AC
outlet. Should you notice an abnormality in the
apparatus, disconnect the main plug from the AC
outlet immediately.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
