11
DRN-XM01C2/XM01CK2/XM01H2/
XM01HK2/XM01R2
4-2. DIAGNOSTIC MODE
4-2-1. SETTING THE DIAGNOSTIC MODE
Press the JOG roller and the preset button 5 simultaneously for
three seconds under the condition of power-off.
Press the JOG roller when the set is powered on.
4-2-2. EXITING THE DIAGNOSTIC MODE
Press the POWER button to exit from this mode.
4-2-3. MENU
Select the menu and press the JOG roller.
DIAG. MODE
SCROLL MODE
RECEPTION STATUS
BER
MENU
MENU
MENU
MENU
JOG roller
4-2-4. OPERATION
[Diagnostic Mode]
Procedure:
1. Select the MENU DIAG. MODE and press the JOG roller.
2. The message “STATE1 QOS Test” is displayed.
3. Select the message(menu) by rotating the JOG roller up or down
as following order.
STATE1 QOS Test
STATE2 Terr
Err
STATE3 Sat1
Err
STATE4 Sat2
Err
STATE5 Tuner Stat
STATE6 Audio Err
STATE7 Gen
Err
STATE8 Ext
Err0
STATE9 Ext
Err1
Up
Down
4. Press the DSPL/BACK/BAND button to return the DIAG.
MENU.
[BER Display Mode]
Procedure:
1. Select the MENU BER and press the JOG roller.
2. The following message is displayed.
XXX1 XXX2 XXX3 E
XXX4 XXX5 X6 X7
XXX1 : SAT1 BER
(4 digits Hex data)
XXX2 : SAT2 BER
(4 digits Hex data)
XXX3 : TERR BER
(4 digits Hex data)
XXX4 : RS Error Byte
(4 digits Hex data)
XXX5 : RS Error Block
(4 digits Hex data)
X6
: SAT AGC
(2 digits Hex data)
X7
: TER AGC
(2 digits Hex data)
E
: Ensemble
(A, B or space)
3. Press the DSPL/BACK/BAND button to return the DIAG.
MENU.
4-3. SYSTEM ERROR LIST
If system error is happened, the message of system error is displayed
and the set sounds beep.
SYSTEM ERROR xx
XXXXXXXXXXXXXXXXXXXX
TUNER UNLOCKED
INFORMATION OF ERROR
(XXXXXXXXXXXXXXXXXXXX)
DSP NO RESPOND
DSP INCORRECT RESP.
UNSUPPORTED DSPSW
CDEC NO RESPOND
I2C BUS ERROR
EEPROM ERROR
EEPROM FORMAT ERROR
CAP ERROR
xx : Error information per bit
MENU
