6-18
DSC-H50_ADJ
2-3. Wide Limit Adjustment
[Adjusting method]
1) Click the
[Start]
button of Camera Adjustment 2, and the fol-
lowing screen will appear.
The buttons on this screen provide the following functions.
[Read Save]
button
•
Saves the wide limit data (2-byte data) read out from the set
into a file.
•
Displays a “Wrong Data Error” message if the data value is
not correct.
•
Default file name is as follows:
[Load Write]
button
•
Writes the wide limit data (2-byte data) read out from the
file into the camera memory.
•
Displays a “Wrong Data Error” message if the value read
out from the file is not correct.
[Manual Write]
button
•
Writes the entered wide limit data (2-byte data) into the cam-
era memory.
•
Displays a “Wrong Data Error” message if the input value
is not correct.
2) When the lens was replaced, enter the wide limit data given on
the data sheet of the replacement lens for service into the screen,
and press the
[Manual Write]
button.
3) When the SY-201 board was replaced, press the
[Load Write]
button.
4) Upon successful completion of the data writing, the following
screen will appear.
Perform the Flange Back Adjustment.
2.
CAMERA Adjustment 2
Perform this adjustment only when replacing the lens block or
SY-201 board.
Adjustment Block
11
Adjustment Page
61
Adjustment Address
0F18, 0F19
2-1. Preparation when the lens is replaced
When replacing the lens, write down the wide limit data given on
the data sheet of the replacement lens for service.
Note:
The wide limit data of lens is written only repair parts.
Fig. 6-1-17
2-2. Preparation when the SY-201 board is replaced
Read out the previous data by using the
[Save]
button of the auto
adjustment program.
Note:
If correct data reading failed, replace the lens together with
the SY-201 board.
Wide Limit Data (2-byte data)
XXXX
XXXX
DSC-H50_WLIMIT_xxxxxxxx_yyyymmdd.dat
Date
USB serial number
Data name
&
&
&
