71
Tr
oub
lesh
oo
ti
n
g
The battery remaining indicator is incorrect, or sufficient battery remaining
indicator is displayed but the power runs out too quickly.
•
This phenomenon occurs when you use the camera in an extremely hot or cold location (page
85).
•
When using alkaline batteries/Oxy Nickel Primary Battery (not supplied), the displayed time
remaining may not be correctly indicated.
•
The batteries are discharged. Install new batteries or charged Nickel-Metal Hydride batteries
(not supplied).
•
When using the Nickel-Metal Hydride batteries (not supplied), the poles of batteries or the
terminals of the battery cover are dirty so the batteries are not charged sufficiently. Clean
them with a cotton swab, etc. (page 85).
•
When using the Nickel-Metal Hydride batteries (not supplied), the displayed time remaining
differs from the current one due to the memory effect (page 85), etc. Fully discharge and then
charge the batteries to correct the display.
•
The batteries are dead. Replace them with new ones.
The batteries run down too quickly.
•
You are using the camera in an extremely cold location (page 85).
•
The batteries are dead. Replace them with new ones.
•
When using the Nickel-Metal Hydride batteries (not supplied), charge them sufficiently.
Cannot turn on the camera.
•
Install the batteries correctly.
•
Properly connect the AC Adaptor (not supplied).
•
The batteries are discharged. Install new batteries or charged Nickel-Metal Hydride batteries
(not supplied).
•
The batteries are dead. Replace them with new ones.
The power turns off suddenly.
•
If you do not operate the camera for about three minutes while the power is on, the camera
turns off automatically to prevent wearing down the batteries. Turn on the camera again.
•
The batteries are discharged. Install new batteries or charged Nickel-Metal Hydride batteries
(not supplied).
Your camera cannot record images.
•
Check the free capacity of the internal memory or “Memory Stick Duo” (page 21). If it is full,
do one of the following:
–
Delete unnecessary images.
–
Change the “Memory Stick Duo”.
•
You are using the “Memory Stick Duo” with the write-protect switch, and the switch is set to
the LOCK position. Set the switch to the recording position (page 83).
Batteries and power
Shooting still images/movies