25
Playback
C
h
apt
er 2
P
la
y
ba
c
k
Repeat Playback—Automatic Cyclical Playback
Proceed as follows to perform automatic cyclical playback of recording (repeat
playback) between selected start and end points.
1
Set the desired repeat start and end points using the REPEAT FUNCTION
menu item (see page 40).
You can set points A and B as start and end points by following the
procedure described in the next section.
2
Set the REPEAT MODE menu item (see page 40) to ON.
The REPEAT indicator lights.
3
Press the SET (YES) button to save the new setting and close the menu.
4
Press the PLAY button.
The unit repeats playback between the repeat start and end points set in step
1
.
Setting Points A and B for Repeat Playback
You can set the repeat playback start point (point A) and end point (point B) by
using the current tape position or inputting time code values.
To perform repeat playback after setting points A and B, press the PLAY button
when the REMOTE button is off. When the DSRM-10 Remote Control Unit is
connected to the CONTROL S connector on the front panel, you can also start
repeat playback by pressing its PLAY button with the REMOTE button of this
unit off.
Setting the current tape position as point A or B
Proceed as follows to set the current tape position as point A or B for repeat
playback.
While holding down the SET (YES)
button on the menu control panel,
press the
K
A
or
B
k
button. The time code value of the current tape
position is set as point A or B, and a message “A set” or “B set” is displayed for
0.5 second in the time counter display.
A
B
MARK
Buttons used for setting the
current tape position as point B
Buttons used for
setting the current
tape position as
point A
In the following explanation of how to set points A and B for repeat
playback, these three buttons are referred to as the
K
A
button,
B
k
button, and SET (YES)
button, respectively.
MARK
MARK
