30
Playback
C
h
apt
er 2
P
la
y
ba
c
k
12
Press the
J
or
j
button to increment or decrement the value of the flashing
digit.
Each press of the button increments or decrements the value. Holding the
button down increments or decrements the value continuously. To change
other digits, return to step
11
.
13
Press the SET (YES)
button to confirm the defined value.
The message “NOW SAVING...” is displayed on the monitor screen and
“Saving...” is shown in the time counter display while the new setting is
being saved in memory.
Caution
The new setting may be lost if you power off the unit during the saving
operation. Wait until the saving operation is completed before powering off
the unit.
If you want to discard the changed value
Press the MENU button instead of pressing the SET (YES)
button
to return to the menu display, then press the MENU button again to end the
menu operation without saving the changed value into memory.
After the saving operation is completed, the monitor screen and time
counter display return to the REPEAT FUNCTION setting display as
shown in step
9
.
14
To set point B, refer to steps
5
to
13
. (Select “REPEAT END” in step
5
, “B
POINT” in step
7,
and “B PRESET” in step
9
.)
15
Press the MENU button to close the menu.
Cuing Up to Any Desired Position Set as Point A or B
You can set any desired tape position as point A or B and cue up to the set point
when required. To cue up to point A or B, holding down the
K
A
or
B
k
button on the menu control panel, press the REW button in the tape transport
control section.
For the methods of setting points A and B, see the previous section.
MARK
MARK
