66
Menu Contents
Menu Contents
Setup Menu
The purpose and settings of the setup menu items are
described below.
Indications of menu items and settings
• In the table below entitled “Menu contents,” the
indication of each menu item or setting on the monitor
screen is shown first, then the indication of the same item
or setting in the time counter display of this unit is shown
in square brackets ([ ]).
• Settings preceded by an asterisk (such as *EE) are
factory default settings.
• In the time counter display, one to three “>” symbols
may precede item or setting indications depending on the
current menu level. Larger numbers of “>” symbols
indicate lower menu levels.
Menu contents
Examples:
Indication on monitor
screen
Indication in time counter
display
OPERATIONAL FUNCTION
[Operational]
*
EE
[>>> EE]
OPERATIONAL FUNCTION [Operational]: Operation
settings
Description of settings
REPEAT FUNCTION [> REP
FUNC]:
Make settings for repeat
playback mode.
REPEAT MODE [>>
REPEAT MD]:
Determine whether or
not to put the unit into
repeat playback mode.
*OFF [>>> OFF]:
Do not put the unit into repeat playback
mode.
ON [>>> ON]:
Put the unit into repeat playback mode.
ON (FREEZE) [>>> FREEZE]:
Put the unit into freeze
playback mode. In this case, while the unit is cueing up to
the repeat start point, the freeze picture of the repeat end
point is displayed.
REPEAT TOP [>> REP
TOP]:
Determine whether the
repeat start point is the
beginning of disk or
point A.
*DISK TOP [>>> Disk top]:
The repeat start point is the
beginning of disk.
A POINT [>>> A point]:
The repeat start point is point A as
set by the user.
REPEAT END [>> REP
END]:
Determine whether the
repeat end point is the
end of the video
recorded portion, the
end of disk or point B.
*VIDEO END [>>> VD end]:
The repeat end point is the end
of the video recorded portion.
DISK END [>>> Disk end]:
The repeat end point is the end of
disk.
B POINT [>>> B point]:
The repeat end point is point B as set
by the user.
A PRESET [>> A preset]:
Specify a time code
value to be used as the
setting of point A.
For details, see “Setting Points A and B for Repeat Playback”
on page 41.
B PRESET [>> B preset]:
Specify a time code
value to be used as the
setting of point B.
For details, see “Setting Points A and B for Repeat Playback”
on page 41.
Summary of Contents for DSR-DR1000P
Page 10: ...10 ...
Page 28: ...28 Location and Function of Parts ...
