Sony DSX-A410BT Operating Instructions Manual Download

Page: 20 / 236

EDIT CUSTOM

Registers the functions (SOURCE, ATT, VOL +/–,
SEEK +/–, VOICE, ON HOOK, OFF HOOK) to the
steering wheel remote control:



Rotate the control dial to select the function
you want to assign to the steering wheel
remote control, then press it.



While [REGISTER] is blinking, press and hold
the button on the steering wheel remote
control you want to assign the function to.
When registration is complete, [REGISTERED]
is displayed.



To register other functions, repeat steps



and



(Available only when [STR CONTROL] is set to
[CUSTOM].)

RESET CUSTOM

Resets the setting of the steering wheel remote
control: [YES], [NO].
(Available only when [STR CONTROL] is set to
[CUSTOM].)

Notes



While making settings, only button operation on
the unit is available. For safety, park your car
before making this setting.



If an error occurs while registering, all the
previously-registered information remains. Restart
registration from the function where the error
occurred.



This function may not be available on some
vehicles. For details on the compatibility of your
vehicle, visit the support site on the back cover.

USB MODE

Changes the USB mode: [ANDROID], [MSC/MTP].
(Available only when the USB source is selected.)

(clock time)

Activates the CT function: [ON], [OFF].

AF/TA

(alternative frequencies/traffic

announcement)

Selects the alternative frequencies (AF) and
traffic announcement (TA) setting: [AF-ON], [TA-
ON], [AF/TA-ON], [AF/TA-OFF].
(Available when any source is selected.)

REGIONAL

Restricts reception to a specific region: [ON],
[OFF]. (Available only when FM is received.)

BTM

(best tuning memory) (page 11)

(Available only when the tuner is selected.)

FIRMWARE

(Available only while the source is off and the
clock is displayed.)
Checks/updates the firmware version. For
details, visit the support site on the back cover.

FW VERSION

(firmware version)

Displays current firmware version.

FW UPDATE

(firmware update)

Enters firmware update process: [YES], [NO].
Updating the firmware takes a few minutes to
complete. During the update, do not turn the
ignition to the OFF position, nor remove the USB
device.

Sound Setup (SOUND)

This setup menu is available when any source is
selected.

EQ10 PRESET

Selects an equalizer curve from 10 equalizer
curves or off:
[OFF], [R&B], [ROCK], [POP], [HIP-HOP], [EDM],
[JAZZ], [SOUL], [COUNTRY], [KARAOKE]*,
[CUSTOM].
The equalizer curve setting can be memorized
for each source.

* [KARAOKE] reduces the vocal sound but cannot

fully remove it during playback. Also, using a
microphone is not supported.

EQ10 CUSTOM

Sets [CUSTOM] of EQ10.
Selects the equalizer curve:
[BAND1] 32 Hz, [BAND2] 63 Hz, [BAND3] 125 Hz,
[BAND4] 250 Hz, [BAND5] 500 Hz, [BAND6] 1 kHz,
[BAND7] 2 kHz, [BAND8] 4 kHz, [BAND9] 8 kHz,
[BAND10] 16 kHz.
The volume level is adjustable in 1 dB steps,
from -6 dB to +6 dB.

BALANCE

Adjusts the sound balance: [RIGHT-15] –
[CENTER] – [LEFT-15].