Sony DVF-L700, Operating Instructions Manual

Parts Identification

5

r

DC IN connector

When using monitor mode, connect this to an external 
power supply (10.5 V to 17.0 V DC) using the supplied 
power cable (with “STRAIGHT CABLE” label). When 
using the PMW-F5/F55, connect to the DC OUT 
connector on the battery adaptor.
The power cable (with “STRAIGHT CABLE” label) is 
not necessary when using VF mode, as power is supplied 
via the VF connector.

Use the power cable supplied with this unit.
The power cables (without “STRAIGHT CABLE” 
labels) supplied with units with serial numbers X00001 to 
X00999 are crossover cables. Therefore, they cannot be 
used with units with other serial numbers.

s

MONITOR OUT connector (BNC type)

Outputs the same signal that is input to SDI IN.

• The MONITOR OUT output is only output when the 

power of the unit is set to ON. There is not output when 
power is not being supplied to the DC IN connector, or 
when power is being supplied but the POWER switch 
is set to SAVE.

• The MONITOR OUT output does not meet the output 

standards of a main line channel.

t

SDI IN connector (BNC type)

When using monitor mode, connect this to the SDI OUT 
connector on the camera using a BNC cable.

For details on supported formats, see “Specifications” 
(page 10).

u

– (minus) button

Use this after pressing the BRIGHT, CONTRAST, or 
PEAKING button to change the respective value.

v

+ (plus) button

Use this after pressing the BRIGHT, CONTRAST, or 
PEAKING button to change the respective value.

w

PEAKING adjustment button

Allows you to emphasize the outlines in the image. This 
does not affect the camera’s output signal.

x

CONTRAST adjustment button

Allows you to adjust the contrast in the image. This does 
not affect the camera’s output signal.

y

BRIGHT adjustment button

Allows you to adjust the brightness in the image. This 
does not affect the camera’s output signal.

z

HIGH BRIGHT (high-brightness display) 

button

Brightens the display to improve visibility when shooting 
outdoors. This does not affect the camera’s output signal.
The HIGH BRIGHT indicator lights during high-
brightness display.
The display switches between high-brightness display 
and normal display with each press of the button.
During high-brightness display, the CONTRAST button 
is disabled and the contrast cannot be adjusted.

wj

Flexible arm attachment points

Attach the supplied flexible arm here.

Do not block the ventilation inlet and outlet. Doing so 
may result in internal overheating and malfunctions.

Note

Notes

Note