F:\SONY DVD\2665121E31K56PRU3\SOURCE\2665121E31\01GB05GET-CEK.fm
master page=right
15
H
oo
kups
DVP-K56P
2-665-121-
E3
(1)
Step 3: Connecting the Video Cords
Connect this player to your TV monitor, projector, or AV amplifier (receiver) using a video cord.
Select one of the patterns
A
through
C
, according to the input jack on your TV monitor,
projector, or AV amplifier (receiver).
In order to view progressive signal (525p or 625p) pictures with a compatible TV, projector, or
monitor, you must use pattern
C
.
* Note that using the COMPONENT VIDEO OUT jacks will cause the picture to go blank. In this case, press
the PROGRESSIVE button for more than three seconds. Repeat this step until you see the picture.
A
If you are connecting to a video input jack
Connect the yellow plug of an audio/video cord (not supplied) to the yellow (video) jack. You
will enjoy standard quality images.
With this connection, select “LINE OUT/S VIDEO OUT” (default) by pressing the
PROGRESSIVE button on the front panel.
A
VIDEO
AUDIO
INPUT
L
R
C
P
R
/C
R
P
B
/C
B
Y
COMPONENT
VIDEO IN
B
INPUT
S VIDEO
Audio/video
cord (not supplied)
Component video
cord (not supplied)
(yellow)
TV, projector, or AV
amplifier (receiver)
to S VIDEO OUT
TV, projector, or AV
amplifier (receiver)
(green)
S VIDEO cord
(not supplied)
TV, projector, or AV
amplifier (receiver)
(red)
(green)
(blue)
(red)
to LINE OUT (VIDEO)
l
: Signal flow
CD/DVD player
to COMPONENT
VIDEO OUT
*
(blue)
(yellow)
,
continued