17
H
ook
up
s
A
If you are connecting to a SCART (EURO AV) input jack
Connect the SCART (EURO AV) cord (not supplied). Be sure to make the connections firmly
to avoid hum and noise. When you connect using the SCART (EURO AV) cord, check that the
TV conforms to S video or RGB signals. Refer to the operating instructions supplied with the
TV to be connected. Also, when you set “LINE” to “S VIDEO” or “RGB” under “SCREEN
SETUP” in the Setup Display (page 64), use a SCART (EURO AV) cord that conforms to each
signal.
B
If you are connecting to a video input jack
Connect the yellow plug of the audio/video cord (supplied) to the yellow (video) jacks. You will
enjoy standard quality images.
Use the red and white plugs to connect to the audio input jacks (page 20). (Do this if you are
connecting to a TV only.)
C
If you are connecting to an S VIDEO input jack
Connect an S VIDEO cord (not supplied). You will enjoy high quality images.
D
If you are connecting to a monitor, projector, or AV amplifier (receiver)
having component video input jacks (Y, C
B
, C
R
)
Connect the component via the COMPONENT VIDEO OUT jacks using a component video
cord (not supplied) or three video cords (not supplied) of the same kind and length. You will
enjoy accurate colour reproduction and high quality images. Note that if you set “LINE” to
“RGB” in SCREEN SETUP (page 24, 64), the player does not output component video signals
from COMPONENT VIDEO OUT jacks.
Yellow
White (L)
Red (R)
Yellow
White (L)
Red (R)
Green
Blue
Red
Green
Blue
Red
,
continued