F:\SONY DVD\2666954112 DVP-
NC85H_US\SOURCE\DVP-
NC85H_US\01US05GET-CEK.fm
master page=right
23
H
o
o
kups
DVP-NC85H
2-666-954-11(1)
A
Connecting to audio L/R input
jacks
This connection will use your TV’s or stereo
amplifier’s (receiver’s) two speakers for
sound. Connect using the audio/video cord
(supplied).
• Surround effect (page 45)
TV: Dynamic Theater, Dynamic, Wide,
Night
Stereo amplifier (receiver): Standard, Night
B
Connecting to a digital audio
input jack
If your AV amplifier (receiver) has a Dolby
Digital*
1
or DTS*
2
decoder and a digital
input jack, use this connection.
Connect using a coaxial or optical digital
cord/HDMI cord (not supplied).
• Surround effect
Dolby Digital (5.1ch), DTS (5.1ch)
*1
Manufactured under license from Dolby
Laboratories. “Dolby,” “Pro Logic,” and the
double-D symbol are trademarks of Dolby
Laboratories.
*
2
“DTS” and “DTS Digital Out” are trademarks of
Digital Theater Systems, Inc.
Notes
• After you have completed the connection, be sure
to set “DOLBY DIGITAL” to “DOLBY
DIGITAL” and “DTS” to “ON” in Quick Setup
(page 24).
• When you connect an amplifier (receiver) that
conforms to the 96 kHz sampling frequency, set
“48kHz/96kHz PCM” in “AUDIO SETUP” to
“96kHz/24bit” (page 70).
• The TVS effects of this player cannot be used
with this connection.
• When you connect the player to an AV amplifier
(receiver) using an HDMI cord, you will need to
do one of the following:
– Connect the AV amplifier (receiver) to the TV
with the HDMI cord.
– Connect the player to the TV with a video cord
other than HDMI cord (component video cord, S
VIDEO cord, or audio/video cord).
• When connecting to the HDMI OUT jack,
carefully align the HDMI connector with the jack.
Do not bend and apply pressure to the HDMI
cord.
Yellow
White (L)
Red (R)
Yellow
White (L)
Red (R)
Optical cord
HDMI cord
Coaxial cord
,
continued
