62
Setting the digital output signal
Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 20.
Select “DOLBY DIGITAL” and “DTS” after
setting “DIGITAL OUT” to “ON.”
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, affecting your ears or causing the
speakers to be damaged.
◆
DOLBY DIGITAL (DVD only)
Selects the type of Dolby Digital signal.
◆
DTS (DVD only)
Selects whether or not to output DTS signals.
Note
If you select one of the TVS settings while playing
a DVD, the player does not output Dolby Digital
signals from the DIGITAL OUT (OPTICAL or
COAXIAL) jack (when you set “DOLBY
DIGITAL” in “AUDIO SETUP” to “D-PCM”)
(page 62).
D-PCM
Select this when the player is
connected to an audio
component lacking a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
“DOWNMIX” item in
“AUDIO SETUP” (page 61).
DOLBY
DIGITAL
Select this when the player is
connected to an audio
component with a built-in
Dolby Digital decoder.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOLBY DIGITAL:
DTS:
OFF
STANDARD
DOWNMIX:
DOLBY SURROUND
D-PCM
OFF
DIGITAL OUT:
ON
OFF
Select this when the player is
connected to an audio
component lacking a built-in
DTS decoder.
ON
Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
