43
Soun
d Adjustme
nts
• When playing DVD-RW in VR mode: If you
connected to an AV amplifier (receiver) using the
DIGITAL OUT (COAXIAL or OPTICAL*) jack
and want to switch between the sound tracks, set
“DOLBY DIGITAL” to “D-PCM” in “AUDIO
SETUP.”
* DVP-NS52P only.
Checking the audio signal
format
You can check the audio signal format by
pressing
(audio) repeatedly during
playback. The format of the current audio
signal (Dolby Digital, DTS, PCM, etc.)
appears as shown below.
◆
When playing a DVD VIDEO
Example:
Dolby Digital 5.1 ch
Example:
Dolby Digital 3 ch
◆
When playing a DivX video file on a DATA
CD or a DATA DVD
Example:
MP3 audio
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Centre
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound’s
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
Notes
• If “DTS” in “AUDIO SETUP” is set to “OFF,”
the DTS track selection option will not appear on
the screen even if the disc contains DTS tracks
(page 70).
• MPEG audio signals with more than two channels
will appear as shown above (3/2.1, 2/1), but only
the Front (L) and Front (R) signals will be output
from your two front speakers.
1:ENGLISH DOLBY DIGITAL
3 / 2 .1
Rear (L/R)
Front (L/R)
+ Centre
LFE (Low Frequency
Effect)
2:SPANISH DOLBY DIGITAL
2 / 1
Front (L/R)
Rear
(Monaural)
1:
MP3 128k
Bit rate