19
H
ook
up
s
Hookups
Hooking Up the Player
Follow steps 1 to 4 to hook up and adjust the settings of the player.
Before you start, disconnect the mains leads, check that you have all of the supplied accessories,
and insert the batteries into the remote (page 16).
Notes
• Plug cords securely to prevent unwanted noise.
• Refer to the instructions supplied with the components to be connected.
Step 1: Connecting the Video Cords
Connect this player to your TV monitor, projector, or AV amplifier (receiver) using a video cord.
Select one of the patterns
A
through
C
, according to the input jack on your TV monitor,
projector, or AV amplifier (receiver).
* Connect to
T
LINE (RGB)-TV for DVP-NS705V.
DIGITAL OUT
PCM/DTS/MPEG/
DOLBY DIGITAL
COAXIAL OPTICAL
5.1CH OUTPUT
W O O F E R
L
R
FRONT
REAR
C E N T E R
AUDIO
L
R
VIDEO
LINE OUT
LINE 1 (RGB)-TV
S VIDEO OUT
LINE 2
INPUT
S VIDEO
B
C
A
AUDIO
INPUT
L
R
VIDEO
l
: Signal flow
(yellow)
S VIDEO cord
(not supplied)
Audio/video cord
(supplied)
TV, projector or AV
amplifier (receiver)
TV, projector or AV
amplifier (receiver)
to LINE OUT (VIDEO)
to S VIDEO OUT
CD/DVD player
SCART
(EURO AV)
cord (not
supplied)
TV
VCR
connecting the VCR
to
T
LINE 1
(RGB)-TV
*
to
t
LINE 2
(DVP-NS905V only)
(yellow)
,
continued