41
Soun
d Adjustme
nts
• When playing DVD-RW/DVD-R in VR mode: If
you connect to an AV amplifier (receiver) using
the DIGITAL OUT (COAXIAL or OPTICAL)/
HDMI OUT jack and want to switch between the
sound tracks, set “DOLBY DIGITAL” to “D-
PCM” in “AUDIO SETUP.”
Checking the audio signal
format
You can check the audio signal format by
pressing
(audio) repeatedly during
playback. The format of the current audio
signal (Dolby Digital, DTS, PCM, etc.)
appears as shown below.
◆
When playing a DVD VIDEO
Example:
Dolby Digital 5.1 ch
Example:
Dolby Digital 3 ch
◆
When playing a DivX video file on a DATA
CD or a DATA DVD
Example:
MP3 audio
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Centre
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound’s
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
Note
If “DTS” in “AUDIO SETUP” is set to “OFF,” the
DTS track selection option will not appear on the
screen even if the disc contains DTS tracks
(page 71).
1:ENGLISH DOLBY DIGITAL
3 / 2 .1
Rear (L/R)
Front (L/R)
+ Center
LFE (Low
Frequency Effect)
2:SPANISH DOLBY DIGITAL
2 / 1
Front (L/R)
Rear (Monaural)
1:
MP3 128k
Bit rate
Summary of Contents for DVP-NS76H
Page 1: ...2 666 956 12 1 Operating Instructions 2006 Sony Corporation DVP NS76H CD DVD Player ...
Page 82: ......
Page 83: ......