30
: Connecting to the 5.1ch input jacks
You can enjoy 5.1ch surround sound using
the internal Dolby Digital, MPEG audio,
DTS, or Super Audio CD Multi decoder of
this player. Note that 7.1-channel MPEG
signals are mixed down to 5.1-channel
signals.
: Connecting to a digital jack
This connection will allow you to use the
Dolby Digital, MPEG audio, or DTS decoder
function of your AV amplifier (receiver). You
are not able to enjoy the surround sound
effects of this player.
z
Hints
• For connection
For correct speaker placement, refer to the
instructions of the connected components.
• To enhance the sound performance:
– Use high-performance speakers.
– Use front, rear, and centre speakers of the same
size and performance.
– Place the subwoofer between the left and right
front speakers.
Notes
For connection
• After you have completed the connection, be sure
to set “DOLBY DIGITAL” to “DOLBY
DIGITAL” and “DTS” to “DTS” in Quick Setup
(page 31). If your AV amplifier (receiver) has an
MPEG audio decoder function, set “MPEG” in
“AUDIO SETUP” to “MPEG” (pages 81).
Otherwise, no sound or a loud noise will come
from the speakers.
• When you connect an amplifier (receiver) that
conforms to the 96kHz sampling frequency, set
“48kHz/96kHz PCM” in “AUDIO SETUP” to
“96kHz/24bit” (page 82).
• Super Audio CD audio signals are not output from
the digital jack.
D-1
D-2
D-2
D-2
