82
• 48kHz/96kHz PCM (DVD VIDEO only)
Selects the sampling frequency of the audio
signal.
Notes
• Even if you set “48kHz/96kHz PCM” to “96kHz/
24bit,” the sampling frequency is converted to
48kHz/16bit when a “SURROUND” mode (page
59) is selected.
• The analog audio signals from the AUDIO OUT
L/R jacks and 5.1CH OUTPUT jacks are not
affected by this setting and keep their original
sampling frequency level.
Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound,
set the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume of the speakers to the same
level.
This setting is effective when connecting the
speaker with 5.1 CH OUTPUT jacks (page
29).
You can create two different Speaker Setup
settings, one for Super Audio CDs and one for
all other types of discs.
When nothing is set in “SUPER AUDIO
CD,” the “DVD” setting you have set
becomes effective when you play Super
Audio CDs.
1
Follow steps 1 through 4 of “Using
the Setup Display” (page 74) to
select “SPEAKERS SETUP” in the
Setup Display.
2
Select “DVD” or “SUPER AUDIO
CD” using
X
/
x
, then press ENTER.
Example: when “DVD” is selected.
48kHz/16bit
The audio signals of DVD
VIDEOs are always converted
to 48kHz/16bit.
96kHz/24bit
All types of signals including
96kHz/24bit are output in their
original format. However, if the
signal is encrypted for
copyright protection purposes,
the signal is only output as
48kHz/16bit.
SPEAKER SETUP
SUPER AUDIO CD:
DVD:
SPEAKER SETUP (DVD)
DISTANCE:
LEVEL(FRONT)
:
LEVEL(REAR)
:
OFF
TEST TONE:
FRONT:
CENTER:
YES
LARGE
LARGE
LARGE
REAR:
SUBWOOFER:
SIZE:
