9
7.
After soldering all the pins, run a dental pick across the pins to see if
movement reveals an unsoldered one.
9.
Using a low flux solder means you do not have to clean the board of
flux with a flux remover…
8.
Most technicians forget to inspect for bridges after installing the IC.
When power is turned ON, a bridge will take out the new IC or dam-
age another related parts. Therefore it is important to inspect the pins
for bridges before approving your own work.
10.
Remove the excess flux by spraying the area lightly with flux remover.
11.
Place a towel over the work and dab the flux off with the stiff bristles of
the brush. This leaves the work clean without the cotton fibers leftover
had you used a cotton swab.
Sony is a registered trademark of Sony.
Chip Quick is a registered trademark of Chip Quick Inc; Mashpee, Mass.
Summary of Contents for DVP-S300
