Sony DWA-F01D, Operating Instructions Manual

6

Parts Identification

Left Side

a

AES/EBU OUT connector (BNC 
type)

Outputs AES3-format digital audio signals.

b

WORD SYNC IN (word sync input) 
connector (BNC type)

Accepts external sync signal.
When the DWR-S01D is attached and the 
sync signal is input, the DWR-S01D can be 
operated in synchronization with the whole 
audio system. In order for the DWR-S01D 
to operate in synchronization, select 
“AUTO” or “EXTERNAL” on the SYNC 
SOURCE indication of the UTILITY menu 
of the DWR-S01D. For details, see “On 
Connecting Word Clock Sync Signal and 
Digital Audio Signal” on page 9.
Note that this connector does not work 
when the WRR-855S is attached.

For details on the frequency of the sync signal, refer 
to the Operating Instructions supplied with the 
DWR-S01D.

Even when the 75-ohm termination has 
been added on the DWR-S01D, this 
connector still works as the high-impedance 
input connector while the DWR-S01D is 
turned off.

c

Monitor volume adjuster

Adjusts the audio volume for monitor 
output.
Adjustment is enabled only when PHONES 
is selected with the output selector switch.

d

Output selector switch

Selects the output of the OUTPUT 1/2 
connector.
PHONES: Allows you to connect 
headphones to the OUTPUT 1/2 connector 
to monitor audio signals.
MIC LEVEL: Allows you to connect a 
portable recorder or similar device to the 
OUTPUT 1/2 connector to record audio 
signals. The output level is fixed.
MIC LEVEL is selected under factory 
default settings.

• When a WRR-855S is installed, audio is 

not output from the right channel.

• As noise may be generated from the 

output of a connected device, be sure to 
lower the input or volume from the 
device to be connected before connecting 
to another device.

1

2

3

4

5

6

Note

Notes