66
Chapter 3 Connections and Settings
Chapter 3 Connections and Settings
The software and online manual for this unit are
supplied on a CD-ROM disc. Software upgrades may
also be provided on CD-ROM discs.
This section will explain the basics of handling floppy
disks.
Inserting and removing CD-ROM discs
Inserting CD-ROM discs
Proceed as follows to insert a CD-ROM disc.
1
Press the EJECT button to bring the tray out.
2
Place the CD-ROM disc on the tray with the label
side up.
Be careful to place the disc so that it is level on the
tray.
3
Press the EJECT button to close the tray.
Removing CD-ROM discs
To remove a CD-ROM disc, press the EJECT button
to bring the tray out, lift the disc from the tray, and
press the EJECT button again to close the tray.
If the tray does not come out when you
press the eject button
First shut down the system using the procedure
explained in “Shutting Down the System” (page 26).
Then open the tray as follows.
Insert a tool with a long metal tip into the emergency
eject hole, and push in until the tray cover opens
slightly. When the tray cover opens, grasp it and pull
the tray the rest of the way out.
CD-ROM drive names
To read the data from a CD-ROM disc, you must
specify the drive name of the CD-ROM disc drive. The
CD-ROM disc drive of this unit has the drive name
“D:”.
Label side up
Using CD-ROM Discs
Emergency eject hole