1-11
EVI-D100/EVI-D100P
Flexible flat cable
Cable guide assembly
Cable cover (lower)
Hook
Projections
Projections
DC motor
2
x
4
2
x
4
Cable retainer
2.6
x
4
Tilt chassis
Hook
Hook
Fig.A
1-5. Flexible Flat Cable
1.
Remove the pan cabinet (side). (Refer to Section 1-2-1)
2.
Remove the pan cabinet (front). (Refer to Section 1-2-2)
3.
Remove the pan cabinet (rear). (Refer to Section 1-2-3)
4.
Remove the camera cabinet (upper/lower). (Refer to
Section 1-2-4)
5.
Remove the camera cabinet (front). (Refer to Section
1-2-5)
6.
Remove the cabinet base (front). (Refer to Section 1-2-6)
7.
Remove the camera block. (Refer to Section 1-3)
8.
Remove the cabinet base (rear). (Refer to Section 1-2-7)
9.
Remove the MDR-16/SE-616 boards. (Refer to
Section 1-4-8)
10. Remove the three screws (2
x
4), then remove the tilt
chassis.
11. Remove one screw (2
x
4), then remove the three
flexible flat cables and cable retainer from the DC
motor.
12. Remove the three hooks from the cable cover (lower),
then remove the cable cover (lower).
13. Remove the three screws (2.6
x
4), then remove the
cable guide assembly.
14. Connect the flexible flat cable in the reverse order of
steps 1 to 13.
