AGC ADJUSTMENT
Adjustment specification:
Simple adjustment
Procedure:
1.
2.
3.
4 .
5.
Receive the TV broadcast.
Turn and adjust RV201 so that the snow noise is shown.
Reversely turn and set RV201 to the point where the
snow noise disappears.
Receive the broadcast for each channel, and check if
there is not beat image distortion of snow noise caused
by mixed demodulation.
If there is beat and image distortion of snow noise,
readjustment the RV201.
Adjustment using SSG
Input the monochromatic gradation wave to the EXT
ANT IN jack
75 terminator)
Receive the VHF- high band. (US, channel 9)
Connect a digital multitester to pin 2 of
Adjust RV201
so that the Volt is 1.770 0.03 V.
JNING ADJUSTMENT
Procedure:
1. Short
(CH
where the green display
bar is shown on the screen.>
2. Receive the broadcast of 2ch by pushing
(CHANNEL
or
(CHANNEL
3. Adjustment RV103 so that the display bar is
corresponded to the position of 2ch.
4. Receive the broadcast of
and adjust
so
that the display bar is corresponded to the 13ch.
Note:
Since. the items 3 and 4 will interfere each other, the
adjustment is necessary for 2 to 3 times.
5.
Receive the broadcasts of 2, 6, 7, to
and check if
the display bar is corresponded to each channel.
6. Set
(TV BAND) to the UHF side to check with
the screen if the display bar was turned red.
7. Receive the broadcast of
and adjust RV104 so
that the display bar is corresponded to the position of
14ch.
8. Receive the broadcast of
and adjust RV102 so
that the display bar is corresponded to the position of
69ch.
Note:
Since the items of 7 and 8 will interfere each other,
the adjustment is necessary for 2 to 3 times.
9.
Receive the broadcasts of 14, 30, 40 to
and check
if the display bar in corresponded to the position of
each channel.
10. Disconnect the S104 shorted in the above item 1.
The figure must be within this range.
I
I
Also the display bars are within the range.
Display bar
FLICKER ADJUSTMENT
Procedure:
1. Input the lo-step black and white wave step wave of
the pattern generator (75 and 1 Vp-p) to the A/V
IN jack
2.
Adjust RV307 (BRIGHT control) to display all the steps
with good balance.
3. Watch the black level of the screen from the front.
When RV304 (common signal voltage) is turned, monitor
changes from
white. Adjust RV304 to the
point where balance is good (minimum flicker).
Black level
3-2. RADIO SECTION
AM RF signal
g e n e r a t o r
put the lead-wire
antenna close to
the set.
30
% amplitude
modulation by
signal
Output level : as low as possible
FM RF signal
generator
TP7 (RF
frequency diviation
by
signal
Output level : as low as posible
